Everbuild 5L Lumberjack Clear Triple Action Wood Treatment

Code: 333190
  • £27.99
  • (FREE UK Delivery)
Want it by Wednesday 30th September? Order within 6 minutes and choose Next Day Delivery at checkout.
Item in Stock | Usually dispatched within 24 hours
Loading...

Product Description

 

LUMBERJACK TRIPLE ACTION WOOD TREATMENT takes care of all your wood treatment and preservation needs in the one can. It is a low solvent; low odour solution based on Micro-fine active technology with added fungicides, algaecides and Permethrin to actively kill and protect against all known wood rot; decay, fungi and wood boring insects. The fungicides and algaecides present in these formulations are finely dispersed so that wood penetration and hence effectiveness is much greater than standard wood preservation products

 

LUMBERJACK TRIPLE ACTION WOOD TREATMENT is fast drying and non flammable and application to wet timbers is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery to give long lasting protection from damage caused by wet rot, dry rot, decay; fungi and wood boring insects/larvae.

 

 

Benefits

 

•    Solvent Free formula

•    Non Flammable.

•    Internal and external use.

•    Can be applied to damp timbers..

 

 

Areas For Use

 

For interior and exterior use on wood such as:

•    Sheds and Garages

•    Fencing and Farm Buildings

•    Roof beams and joists

•    Garden Furniture.

•    Floorboards

•    Window frames and doors

 

 

Limitations

 

•    Ready to use - do not dilute.

•    For use only as specified as a surface biocide.

•    Always use coarse rather than fine mist generators.

•    Do not apply to surfaces on which food is prepared.

•    Avoid contact with bitumen, roofing felt or plastics.

•    It is the user’s responsibility to determine suitability for use. If in doubt, contact Technical Services Department for advice.

 

 

Surface Preparation

 

Ensure that surfaces are clean, and free from paint varnish, stain, grease, bark or any other contaminants. Surfaces may be damp.  If decay is already present, remove all decayed wood and replace with sound treated timber. 

 

Precautionary Notes

 

ALWAYS READ STATUTORY CONDITIONS RELATING TO USE BEFORE STARTING ANY WORK. Ensure good ventilation before applying and after application until the treatment has dried (HSE statutory 1 hour re-entry time or until surfaces are dry) NOTE: drying times will be extended in cold weather and if ventilation is restricted. Avoid contact with skin and eyes, Remove any splashes immediately. Clean up spills immediately (to avoid staining) with warm soapy water. 

In roof areas, felt under tiles must be protected from contact with the fluid. Roof insulation’s must be removed and only replaced when treated timbers are thoroughly dry. Water storage tanks must be covered. 

When treating flooring and joists, boards should be left up for as long as possible to assist ventilation/drying. 

Switch off electrical circuits in the area being treated before and for 48 hours after treatment. PVC covered electrical wiring will not normally be affected, but we recommend wiping any excess from cables wherever possible.

 

Application

 

Shake well before use. Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after the first coat has soaked in but before it is dry. Pay particular attention to thoroughly soaking the end grain. Where possible, dip the end grains of the timber for maximum protection.

 

Coverage Guide

 

Joinery, floorboards, furniture roof joists etc:  Apply 1 litre of product per 3 - 4m² of surface.

Ideally this should be applied as 2-3 even coats leaving at least 2 hours between applications or dip for three minutes.

Timber not in ground contact:  3 coats by brush or spray or dip for 10 minutes. Coverage: 4m2 per litre.

Timber in ground contact: Soak for 1 hour. Coverage: 40 litres per cubic meter.

 

For Health & Saftey guidelines please refer to manufacturer's datasheet.

Showing our 1 review for Everbuild 5L Lumberjack Clear Triple Action Wood Treatment. Write a review
Review Summary - 5 out of 5 based on 1 rating.
September 16, 2019 | John Callard
5L Lumberjack Clear Triple Action Wood Treatment

Easy to apply and virtually odourless, seems very good product

Here at Build and Plumb Materials Online, we want you to be 100% happy with your purchase. Alongside this we want to offer outstanding customer service.

We offer free delivery on the majority of our product lines.  Unfortunately, this is not always possible due to various reasons, but we will always endeavour to keep these costs as low as possible.

Next day delivery is available; however, orders for next day delivery must be placed by 12 noon.  Any orders placed for next day delivery after this time, will take 2 working days to be delivered.

Working/delivery days are Monday to Friday, deliveries will not normally be made Saturday or Sunday.

We offer a 30-day returns policy on all of our items, as long as the item is unused, undamaged and in its original packaging, rest assured we will accept your return and give a full refund if the above conditions are met. We only ask that the postage is covered by yourself.

On the rare occasion, if your item is damaged on arrival please let us know within 2 days of receipt of the item so we can organise a new item to be delivered and ask that the damaged item be returned.

On the event of a defect being found upon install or use please contact us immediately to allow us to resolve the issue in accordance to manufacturer / supplier terms and conditions.

For any issues surrounding the return of an item please let us know either by phone on 01228 635022 or by emailing help@buildandplumb.co.uk.

Please contact us for our Payment & Security policy.

Top