1 1/2" (40mm) Bath Trap 50mm Seal -WTB4050

Suitable for 1 1/2" (40mm) Pipe50mm Water SealUniversal Outlet Suitable for Plastic, Copper & Lead PipeManufactured In High Quality Polypropylene

1 1/2" (40mm) Shallow Bath Trap - WTB4019

Quality polypropylene 40mm bath trap with a 19mm seal. Trap uses easy grip compression nuts, tapered rubber seal, rubber 'O' ring and a slip ring to give a secure water tight seal. All Magna traps have a universal outlet suitable for use with push-fit or solvent weld waste pipes. The water seal is the height of water stored in a trap to prevent odours from drainage.

1 1/2" Low Level Bath Trap with 19mm Seal - Q10

19mm water sealMultifit compression outlet suits all plastic, copper and lead pipeSuitable for use with most standard bath wastesManufactured in polypropylene

1 1/2" Space Saver Waterless Bath Trap - WV1

Bath space-saving trap1 1/2" BSP female inlet nut with 1 1/2" universal compression outletThe internal membrane opens under water pressure to allow discharge to flow freely and then closes to form a seal to prevent odourThe valve can be easily cleaned without having to disconnect the discharge pipeworkRemove split pin, plug and membrane and clean in hot soapy waterNo water seal, so can never dry out through evaporation or lack of use, as the membrane seal remains closedOverall height 75mm

1 1/4" Bath Trap with 19mm Seal - P10

Ideal for older cast iron bathes with smaller waste plug holes19mm water sealMultifit compression outlet suits all plastic, copper and lead pipeSuitable for use with most standard bath wastesManufactured in polypropylene