Stick 2 Spray Contact Adhesive

Sprayable Glue 500ml

Sprayable glue which bonds

to most common materials

including

wood, concrete, stone, tiles, rubber foam, metals,

rigid plastics, polyethylene, canvas, fabrics,

cardboard, paper and cork. Ideal for securing most

carpets/floor coverings, the product is suitable for

internal and external use giving excellent permanent or

temporary adhesion, depending on method of application.

Benefits

· Good adhesion - fast rate of tack development.

· Ease of use - no messy spreading/clean up

· Time saving- easier and quicker than most trowel/spreader applied adhesives.

· Foaming formula - gives low soak in into most

substrates.

· Halogen and CFC Free.

Areas For Use

· Subfloors- eliminates the need for gripper rods

· Most joinery applications. Bonds all woods/composite board etc.

· Fixing most common laminate materials*

· Bonding metals to most surfaces.

· Bonds rubber, most plastics and leather

· As a general purpose household/hobby adhesive

Limitations

· Do not use on soft (plasticised) PVC.

· Do not use on polystyrene.

Use EVERBUILD Gun a Nail

· Do not use on cellulose painted surfaces

· Do not use on bitumen or tar leaching products.

· Medium strength adhesive - do not use on heavy/large/thick areas of laminate - Use STICK 2 ALL PURPOSE CONTACT ADHESIVE.

Surface Preparation

The surfaces to be glued should be clean and free from dust, grease and other contaminants.

Materials should be stored in a warm environment prior to bonding to avoid chilling of the glue line, which leads to extended setting times. Application

Shake the can well before use.

Select the fan width by turning the nozzle to the

desired position. Spray adhesive from 6-8 inches

away onto one or both surfaces; depending on the

type of surface/strength of bond required.

The surfaces to be glued should be clean and free

from dust, grease and other contaminants. Shake

well before use. Select fan width by turning to

desired setting. Spray adhesive from 6 to 8 inches

(15 to 20 cms approx.) away onto one or both

surfaces, depending on type of strength of bond

required.

STRONG BONDING

Apply 1-3 coats (depending on strength required) to both surfaces. Allow solvent to evaporate (30 seconds) and press surfaces together from centre outwards.

TEMPORARY RE-POSITIONABLE BONDING:

Spray on one surface only and allow to dry for 2-3 minutes before bonding. Excess adhesive can be removed with STICK 2 CONTACT ADHESIVE THINNER AND CLEANER. To prevent spray nozzle from blocking, at the end of each day, turn can upside down and press nozzle until spray is clear of adhesive. Excess adhesive can be removed using

EVERBUILD GUN FOAM CLEANER.

To prevent spray nozzle from blocking at the end of each use, turn can upside down and press nozzle until spray is clear of adhesive.

The newly bonded materials should not be subjected to extreme temperature changes for 3 to 4 days after bonding. Avoid further fabrication until

the adhesive has fully cured.