A remarkable fusion of natural limestone and travertine that elevates any outdoor area with its exquisite and distinct mottled finish.

Crafted with precision, the Raptura Porcelain Paving offers seamless installation when laid with meticulous attention to detail. It is essential to mix tiles from different packs to achieve a harmonious appearance, as batch variations may cause slight differences in colour and texture. Remember to retain the batch code for future reference, should additional tiles be necessary. During installation, use a flexible jointing grout and apply a priming slurry to the underside of each tile. Ensure the pavers are set on a full wet mortar bed with a specific sand-to-cement ratio, and cut with a porcelain cutting blade for the best results. Create a stunning, continuous surface by employing rectified tiles for precise alignment.

• Size: 900 x 600mm, 20mm thickness
• Stunning blend of natural limestone and travertine
• Suitable for outdoor spaces
• Requires full wet mortar bed for installation
• Priming slurry needed before laying
• Use a porcelain cutting blade for trimming
• Colour: Grey

Porcelain notice:

Porcelain paving is manufactured in batches, this means the colour and texture can vary by the batch. Ensure you mix tiles from each of the packs that are being laid. This means an overall tone will be achieved showing no colour discrepancies. If you lay paving using one pack at a time it can create visible colour differences. It is also important to keep a note of the batch code of the porcelain, in the event you need more tiles.

Laying instructions:

When laying the paving you will also need a flexible jointing grout, but ensure this does not dry on the surface of the tiles. Some porcelain paving tiles are rectified, rectified tiles ensure precise dimensions for seamless flooring, allowing for closer jointing to create a unified, uninterrupted surface. They must be laid on an MOT Type 1 or GSB aggregate sub-base, or over a geo-textiles covering.

Tiles need to be set on a full wet mortar bed (40mm), using a 5:1 Sharp sand : cement ratio and the tiles should be cut with a circular Porcelain Cutting Blade (no teeth) using hand tools, or a table saw and water dust suppression.

Prior to laying the tiles, ensure you use a priming slurry, which needs to be applied to the underside of each paving tile.